Syvecs S8 ECU Standalone Engine Management
£3,985.00 ex VAT
The Syvecs S8 ECU is our most popular standalone engine management unit.
It offers 24 x Inputs, 28 x Outputs, 2 x Lambda Inputs, 2 x Knock Inputs, 2 x EGT Inputs and 2 x DBW Drivers. All software features are enabled from the factory except for Direct Injection Control and Paddle-shift Control which are an optional upgrade.
The Syvecs S8 ECU offers an extremely high level of precise engine management control.
The twin processor unit uses a high speed RISC processor for code execution and an additional large FPGA for high speed engine position tracking. This allows the scheduling of code to be independent of signal patterns, increasing flexibility, efficiency and accuracy under transient conditions. This powerful combination also allows advanced control algorithms while remaining easy to map for the end user.
Cased in a sealed aluminium billet unit with 1 x waterproof connector offering 88 pins.
Syvecs S8 ECU Inputs
24 x General Purpose Analogue Inputs:
16 x 5V/Bipolar, Sensor/Sync/Speed, Programmable Trigger Voltages
4 x 5V Sensor Input
4 x Thermistor Sensor Input
2 x NTK Lambda Inputs
2 x K-Type Thermocouple Circuit
2x Knock Input
Syvecs S8 ECU Outputs
28 x High/Low Side Driver Outputs:
4 x Half Bridge Outputs (Max 10 Amps)
16 x Low Side Injection/PWM Outputs (Max 10 Amps)
8 x TTL / IGBT Ignition Drivers
Syvecs S8 ECU Comms
2 x Can 2.0B
1 x Rs232 Output
100 Mhz Full Duplex Ethernet For Connection To PC For Programming And Data Download
Up to 64MB Internal Logging Memory aswell as Onboard Laptop Logging
6 to 20v input voltage range with reverse polarity protection
2 x regulated 5V sensor supply outputs with protection
Operating Temperature -25 to +95 C
Dimensions 178 x 122 x 36 mm